The new and improved Polywater® Lubricant Pump Model LP-D5 is a drill-operated, self-priming gear pump.   All Polywater® lubricants can be pumped directly into the conduit or onto the cable during cable installations at rates exceeding 1.5 gallons per minute. The LP-D5 pump sets directly onto a 5-gallon pail or 55-gallon drum and comes with a 10-foot discharge hose.   Click here to see the LP-D5 in field use on a large power utility cable installation project. The LP-D5 pump now includes two hands-free applicators (shown at right) for 1.5-inch to 6-inch conduits.

ADVANTAGES
Practical Transfer of all Polywater® Lubricants -- Save time and effort in cable pulling.   Eliminate hand scooping, messy pouring, and lengthy clean-ups.
Variable Pumping Capability -- Adjustable speed ½-inch drill (not included) allows pump to deliver lubricants at a rate of 1.5 gallons per minute, or higher.
Consistent Lubricant Application -- Automates lubricant application with constant lubrication throughout installation.
Convenient -- No hand pumping.   Requires battery or electric variable speed ½-inch drill.
Easy Maintenance -- Minimum assembly required.   Cleans up with water.
Corrosion Resistant -- A solid brass body and stainless steel shaft.

Open pail or drum.   With drum, untie and open liner, then replace drum cover.   Set LP-D5 pump in 5-gallon pail or into the 2-inch bung hole of a 55-gallon drum.   Attach variable speed drill to LP-D5.   Insert free end of hose into conduit opening, pail or jug.   Set drill to OPERATE IN FORWARD.   Start drill to pump lubricant until it is visible at hose end.   If installing cable, start pulling cable and start variable speed ½-inch drill to pump lubricant at desired flow rate.

Pump clean tap water through LP-D5 pump until water discharge is clear and no lubricant is apparent.   Let pump containing tap water soak for 15 minutes.   Run pump again with clean tap water to remove any remaining lubricant.   Repeat the process as necessary.   Wipe off pump.   Protect from dirt with bag or other cover.

Keep dirt and debris away from pump to avoid damage.   Avoid running pump dry to prevent damage.

Important Notice: The statements and information here are made in good faith based on tests and observations we believe to be reliable. However, the completeness and accuracy of the information is not guaranteed. Before using, the end-user should conduct whatever evaluations are necessary to determine that the product is suitable for the intended use. The user assumes all risks and liability in connection with such use. The statements contained herein are made in lieu of all warranties, express or implied, including, but not limited to, implied warranties of merchantability and fitness for a particular purpose, which warranties are hereby expressly disclaimed. American Polywater's only obligation shall be to replace such quantity of the product proven to be defective. Except for the replacement remedy, American Polywater shall not be liable for any loss, injury or damage, direct or indirect, arising from the use or the failure to properly use these products, regardless of the legal theory asserted. The foregoing may not be altered except by a written agreement by the officers of American Polywater Corporation.

This website uses third party cookies to analyze navigation and to improve the quality of the user experience. If you continue browsing, you accept cookie use as set out in our Privacy Policy. Address: 11222 60th Street N, Stillwater, MN 55082, USA Phone: +1 651 430-2270 | Fax: +1 651 430-3634 | Phone: 800 328-9384 (Toll-Free USA/Canada) General Email: Email Contact Page